ESP32 flash

Write an ESP32 app image over USB. Chrome and Edge on a computer use Web Serial. Chrome on Android uses WebUSB and Espressif's serial polyfill. The flasher is esptool-js.

Image

GHCR copies are the same firmware.bin the desk frame pulls for OTA. This page does not check Cosign. Flash from a computer you trust. A board still on the factory partition table needs a one-time make bootstrap from inkbot-esp32 before this page can write the OTA slots.

Source
CORS proxy

GHCR does not send CORS headers, so this page fetches through cors-proxy. If you run your own Worker, add ?proxy=.

No image loaded.

Flash

checking

Checking for Web Serial or WebUSB.

Plug in the Waveshare ESP32 driver board. The write replaces both app slots and leaves NVS alone, so Wi-Fi keys stay. If connect fails, hold BOOT, tap RESET, then try again. After a successful write, tap RESET without holding BOOT if the panel does not change. E-ink keeps the last picture until the new firmware paints.

Log